Electrical Harness Toolbars

This section describes the various toolbar commands available in the Electrical Harness workbenches.
The toolbars are located on the right in the default set-up except for the Catalog Browser, the Measure and the Update commands which are located in the horizontal bottom toolbar.

Electrical Harness Assembly Workbench Toolbars

Creation Toolbar
Bundle Segments Sub-toolbar
Management Toolbar
Delete Toolbar
Related Objects Toolbar
Catalogue Toolbar
Measure Toolbar
 

Creation Toolbar

	Geometrical Bundle See Creating a Geometrical Bundle
	See Bundle segments sub-toolbar below
	Local Slack See Managing Local Slack
	Protective Covering See Adding Protective Coverings

Bundle Segments Sub-toolbar

	Bundle Segment See Working with Single Bundle Segments in a Bundle Segment Document
	Multi-branchable Document See Creating a New Multi-Branchable Document and First Branch

Management Toolbar

	Link See Linking Bundle Segments
	Unlink See Unlinking Bundle Segments
	Add Support See Adding a Support
	Remove Support See Removing a Support
	Split See Splitting Bundle Segments
	Add Branch Point See Adding Branch Points
	Remove Branch Point See Removing Branch Points
	Transfer Branches See Transferring Branches
	Duplicate Harness See Duplicating Harnesses
	Adjust See Adjusting Relationships between Harness Covering Components
	Arrange Bundle Segments See Arranging Bundle Segments in Supports
	Copy Bundle Segment Position See Copying the Bundle Segment Arrangement
	Update Bundle from Support See Updating the Bundle Segment-to-Support Link

Delete Toolbar

Delete Special See Deleting Unused Branch Points

Related Objects Toolbar

Related Objects See Viewing Related Objects

Catalogue Toolbar

Catalog Browser See Using the Catalog Browser

Measure Toolbar

Measure Geometrical Bundle Inertia See Measuring Geometrical Bundle Inertia

 
Electrical Harness Installation Toolbars

Select Toolbar
General Toolbar
Geometrical Element Toolbar
Delete Toolbar
Internal Protection Toolbar

Select Toolbar

Exit See Exiting the Installation Workbench (Part workbench)

General Toolbar

	Bundle Segment Definition See Working with Single Bundle Segments in a Bundle Segment Document
	Branch Definition See Creating a New Multi-Branchable Document and First Branch
	Add Branch Point See Adding Branch Points
	Remove Branch Point See Removing Branch Points

Geometrical Element Toolbar

	Point See Creating Construction Constraints, Creating Points
	Line See Creating Lines
	Plane See Creating Planes

Delete Toolbar

Delete Special See Deleting Unused Branch Points

 Internal Protection Toolbar

Light Protective Covering See Adding Light Protective Coverings